United Security Products AVD-45c Manuel d'instructions

United Security Products Model AVD-45b Automatic Voice Dialer Installation and Instruction Manual Patents Pending

- 10 -PROGRAMMING THE DIALER Example 1: Store pager number 555-1212 and numeric message 911 in Location 1. Press: Example 2: Store pager number

- 11 - Programming Tone/Pulse and PBX 1. Press the “M” key until “PROGRAM: NUMBERS” appears in the LCD, then press “2”. 2. Press “1” (YES) at the “

- 12 - 7 Immediately after selecting Exit and Entry delays, the LCD displays input options; N.O./N.C. for either normally open or normally closed

- 13 - To verify telephone numbers and OGM without phone line connection Follow these directions to ensure the correct telephone numbers have be

- 14 - 8. The AVD-45b will sequentially dial the programmed Locations (1-4). If there is no number stored in a location, it will be skipped. The OG

- 15 - LOCATION Place the dialer on a flat level surface or mount the unit on the wall, away from extreme cold or heat, direct sunlight, excessive

- 16 - Federal Communications Commission Radio And Television Interference Statement For A Class ‘B’ Device This equipment generates and uses radio

- 17 - ??Non volatile (EEPROM) memory for voice message and phone numbers ??Calls up to 4 phone numbers, any combination of telephones or pagers ?

- 18 - Consult factory for availability and pricing 24V APPLICATION: AVD-45b/F - For this option the dialer is configured to operate at 24VDC to 3

- 19 - FCC PART 68 INFORMATION SUPPLIED TO THE USER This equipment complies with Part 68 of the FCC Rules. The FCC Part 68 Label is located on the bo

- 2 - Thank you for purchasing United Security Products Model AVD-45b, the single channel voice dialer that can be incorporated into hard wired or

- 20 -Model AVD-45b Automatic Voice/Pager Dialer SPECIFICATIONS: Power requirements: 9-18VDC Current draw (OPERATE mode - Stand By): 28mA

- 3 -987P*R M0#415 62 3AVD-45bAutomatic Voice DialerAVD-45b PANEL DISPLAY 9V ALKALINE BATTERY LCDSpeaker MIC Keypad Mode Program/ Pause TEL LINE

- 4 - N.C./N.O. DRY CONTACT ACTIVATION HOOKUP PP-1 STANDBY BATTERY (optional) PANEL OR SENSOR NC, NO, MOMENTARY, OR CONTINUOUS ALARM ACTIVATION

- 5 - VOLTAGE LEVEL ACTIVATION HOOKUPWHEN THE ALARM OUTPUT VOLTAGE IS RELAY DRIVEN, YOU MUST ADD A 1K RESISTOR ACROSS ALARM OUTPUT TERMINALS. HOOK

- 6 - IMPORTANT: Before operating the AVD-45b, make sure wiring is correct and power is set within specified limits. Recording and data recall can

- 7 - How to store phone numbers Follow these directions to store up to 4 telephone numbers in the dialer’s memory. Please remember that local or

- 8 - PROGRAMMING THE DIALER Example 1: Store telephone number 1-800-555-1212 in Location 1. Press: Example 2: Store telephone number 555-1212 i

- 9 - To store a pager number and numeric code 1. With the dialer at the “PROGRAM: NUMBERS” prompt, press “1” (YES). 2. Enter all the digits of the